Furry, Fuzzy Steering Wheel Cover

Furry, Fuzzy Steering Wheel Cover
Originally uploaded by Unkoine.

Skill Level: Beginner
For ANY SIZE steering wheel!
(Real Car, Toy Car, Lawn Mower, or Grandpa's Tractor!)

Yarn
· 1 skein Eyelash Yarn (I used leftover scraps of Lion Brand Fun Fur for a cool, funky look!)
· 1 skein Worsted Weight Yarn in a coordinating color (I used Red Heart Kids Yarn - Pink)
Both yarns will be held together throughout

Materials
U.S. Size 10 knitting needles, yarn needle for sewing

Directions
Before you start knitting, take a piece of string (one that WILL NOT STRETCH), and measure around the outside edge of your steering wheel. (Area to measure is shown in green in the schematic link.) Cut the string about one inch longer to allow room for a seam. This is the perimeter of your steering wheel. It’s not necessary to measure it, because you’ll just hold your knitting up to it later to see if it’s the right length. You should also cut a piece of string to measure around the thickness of your steering wheel. (You will NOT add an inch to that.)

Using one strand of each yarn held together, loosely cast on 10 to 15 stitches. (as many stitches as it takes for the thickness of your steering wheel.) Knit a few rows and check again to see if it’s the right width. (Use the short piece of string that you cut earlier as a guide.) If it’s not the right width, start over, because the cover has to be TIGHT around the wheel for safety!

Knit every row. Occasionally check to see if your knitting is long enough by stretching it out and measuring it against the longer string you cut earlier. (Don’t forget to STRETCH your knitting, since it needs to be tight around the steering wheel for safety.)

When it’s long enough, bind off loosely, and weave in the end of the eyelash yarn. Leave a long end of worsted weight free so you can use it for sewing. (The loose end of yarn should be at least 30 inches long.)

Connect the short ends of your knitting and sew a strong seam. Weave in any short ends. Remember to leave the long end of worsted weight yarn loose for sewing the cover to the wheel.

Put your creation around the steering wheel, making sure it’s arranged the way you like. (Be sure the seam you sewed earlier is not showing on the outside of the wheel!)

Using the long end of worsted weight yarn, sew the cover together along the inside edge of the steering wheel. I sewed a stitch at each ridge, and then pulled each stitch nice and tight (shown in red on schematic). When you get to the bars on your wheel, just weave the yarn through the back of the wheel cover (shown in blue on the schematic), then start sewing again at the next open section. When you go full circle to the beginning of your stitching, sew a couple stitches on top of each other to secure your yarn. Weave in the loose end and cut.

Put your hands around your furry steering wheel and smile!

April, 2005 - Designed by Sandy Davis